Bike Riser Installation Guide

This installation guide will help you install your Bikeriser Wall Mounting System.

WARNING: Bikeriser holds no responsibility for incorrectly installed Bike wall mounts.

Step 1: Positioning 

Find the desired position for your bike, move pedals so that the pedal against the wall is at the top of its rotation. Place the bike at the desired height with both tyres and the pedal touching the wall. 

A. INSTALLING IN DRYWALL (TIMBER SUPPORTS)

1. Locate the centre of the timber studs using a stud finder. 
2. Line up the pedal with the stud.

B. INSTALLING IN MASONARY 

1. Any position is okay, just avoid mortar between bricks if possible. 

Step 2: Mark Wall 

With a pencil/marker put a line on the wall where the top of the pedal meets the wall.

Step 3: Mark Holes

Line up the bottom of the Bikeriser pedal hook to the line on the wall. Use a spirit level to make sure it is straight and mark the holes. 

Step 4: Pre-drill Holes 

A.  INSTALLING IN DRYWALL (TIMBER SUPPORTS)

With a 3mm drill bit, drill the pilot holes. If one of the markings has missed the beam, use a slightly larger drill bit and drill a hole suitable for one of the dry wall anchors. Then use a hand screw driver to drive in the threaded dry wall anchor.

B.  INSTALLING IN MASONARY

Use a larger masonry drill bit, suitable size for wall plugs and pre-drill holes. Push in wall plugs.

Step 5: Attach Pedal Hook

Place the pedal hook back in position and tighten screws.

Step 6: Find Position of Tyre Mounts

To find the correct position of the tyre mounts, place your pedal into the mount. Make sure the bike is level and mark the lowest points where the tyres contact the wall. 

Step 7: Mark Holes

Line up the bottom of the Bikeriser tyre mount to the line on the wall. Use a spirit level to make sure it is straight and mark position holes.

Step 8: Pre-drill and Attach Tyre Mount

With a 3mm drill bit, drill the pilot holes. If one or both of the markings have missed a beam, use a larger drill bit and drill a hole suitable for the wall anchors. Push in or screw in wall anchors, then replace tyre mount and tighten screws. Repeat step 7 & 8 for both tyre mounts.

Step 9: Complete 

Installation complete, your Bikeriser is now ready to use and admire!